Silverado 3500 4WD V8-6.6L DSL Turbo (2010)
1. Position the exhaust differential pressure sensor (2) to the bracket.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the exhaust differential pressure sensor bracket bolts (1).
Tighten the bolts to 9 Nm (80 lb in).
3. Install the exhaust differential pressure sensor pipe assembly hoses to the sensor.
4. Position the exhaust differential pressure sensor pipe assembly hose clamps (3).
5. Connect the chassis wiring harness electrical connector (1) to the exhaust differential pressure sensor (2).
6. Lower the vehicle.