Silverado 3500: Memory Seat Calibration Procedure - Page 15246
1. Position the module into the vehicle.
2. Connect the lower electrical harness connectors (2).
3. Slide the module (2) to the left to engage the lower retainers.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the module retaining screws (3).
Tighten
Tighten the screws to 3 N.m (26 lb in).
5. Connect the upper electrical harness connectors (3).
6. Install the seat cushion.
7. If a new memory seat module was installed, calibrate the seat. Refer to Memory Seat Calibration Procedure.