Silverado 3500 4WD V8-6.6L DSL Turbo VIN 2 (2004)
4. Install the bolts (1) to the rear of the power steering pump.
^
Tighten the rear bolts to 50 Nm (37 ft. lbs.).
5. Install the power steering pump mounting bracket and bolts.
^
Tighten the mounting bracket bolts to 46 Nm (34 ft. lbs.).
6. Install the bolts (2) to the front of the pump.
^
Tighten the power steering pump retaining bolts to 50 Nm (37 ft. lbs.).
7. Install the bolt retaining the battery junction block from the power steering bracket.
^
Tighten the battery junction block retaining bolt to 9 Nm (80 inch lbs.).
8. Install the power steering pulley. Refer to Power Steering Pulley Replacement.
9. Fill and bleed the power steering system. Refer to Bleeding the Power Steering System.