Silverado 3500 4WD V8-6.6L DSL Turbo VIN 2 (2004)
Case: Service and Repair
Transfer Case - NVG 263-NP1
Transfer Case Shield Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield bolts, if equipped.
3. Remove the transfer case shield, if equipped.
Installation Procedure
1. Position the transfer case shield to the crossmember, if equipped.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the transfer case shield bolts, if equipped.
^
Tighten the bolts to 20 Nm (15 ft. lbs.).
3. Lower the vehicle.
