Silverado Classic 1500 2WD V6-4.3L (2007)
14. Remove the round washer.
15. Remove the tang washer.
16. Remove the shim washer (1).
17. Remove the oil seal.
ASSEMBLY PROCEDURE
IMPORTANT: Installing the driven gear 180 degrees out of alignment, or locating the rotor in the wrong holes, will cause a no-start
condition. Premature engine wear or damage may result.
1. Line up the square-cut hole in the vane wheel for the CMP sensor.
2. Install the CMP sensor.
NOTE: Refer to Fastener Notice.
3. Install NEW CMP sensor screws.
Tighten the screws to 2.2 N.m (19 lb in).