Silverado Classic 1500 2WD V6-4.3L (2007)
3. Remove the ignition coil wire from the ignition coil and distributor cap.
4. Remove the spark plug wires from the distributor cap.
-
Twist each spark plug boot 1/2 turn.
-
Pull only on the wire boot in order to remove the wire from the distributor cap.
5. Remove and discard the distributor cap screws.
6. Remove the distributor cap.
7. Using a grease pencil, mark the position of the rotor in relation to the distributor housing (1).
8. Also, mark the distributor housing and the intake manifold.
9. Remove the distributor hold-down bolt.
10. Remove the distributor.
