Silverado Classic 1500 2WD V8-5.3L (2007)
1. Install the handle to the vehicle.
2. If the lock cylinder is a replacement, apply a coating of GM P/N 12345120 (Canadian P/N 726548) or a similar lubricant to the inside of the lock
case and the cylinder keyway.
3. Install the door lock cylinder to the outside handle housing.In order to code a new lock cylinder,
4. Install the lock cylinder clip to the lock cylinder rod.
5. Install the handle rod to the handle assembly clip.
6. Remove masking tape from door handle.
7. NOTE: Refer to Fastener Notice.
Install the outside handle mounting nuts.
Tighten the nuts to 9 N.m (80 lb in).
8. Install the rubber cover.
9. Install the water deflector.
10. Install the trim panel.