Silverado Classic 1500 2WD V8-5.3L (2007)
Seat Belt Buckle: Service and Repair
Front Seat Belt Buckle Replacement
Front Seat Belt Buckle Replacement
Caution: To avoid personal injury to the occupants of the vehicle, observe the following precautions:
* More than one supplier's seat belts are used, therefore, install ONLY the seat belt components specified in the GM parts catalog.
* To verify that the correct seat belt components were installed, insert the seat belt latch in the seat belt buckle. The latch must be fully
seated and be retained in the buckle until purposely released.
Removal Procedure
1. Remove the front seat belt buckle nut (1).
Disconnect the electrical connection (2). The right seat buckle is shown, the left is similar.
2. Remove the seat belt buckle from the vehicle.
Installation Procedure
1. Install the seat belt buckle in the vehicle.
2. Connect the electrical connection (2).
Notice: Refer to Fastener Notice.
3. Install the front seat belt buckle nut (1).
Tighten the nut to 53 N.m (39 lb ft).
