Silverado Classic 1500 2WD V8-5.3L (2007)
2. Slide J 43772 over the turbine shaft and the stator shaft until the seal starts into the seal bore. Strike the J 43772 with a mallet (1) to drive the seal
into the seal bore. The seal is installed correctly when the shoulder of the J 43772 squarely contacts the outer surface of the oil pump.
3. Install the torque converter into the transmission. Refer to Torque Converter Replacement.
Torque Converter Housing Bolt Seal Replacement
Torque Converter Housing Bolt Seal Replacement
Removal Procedure
1. Remove the torque converter from the transmission. Refer to Torque Converter Replacement.
2. Remove any of the 10 bolts (1), bolt heads shaded, where leakage at the bolt head is suspected.
3. Important:
Bolts (1) have a removable seal under the flanged head.
Remove and discard seals from bolts removed.
Installation Procedure
1. Install new seals on any bolts (1) removed.
2. Notice:
Refer to Fastener Notice in Service Precautions.
Install any bolts (1) removed.
Tighten bolts to 56 Nm (41 ft. lbs.).