Silverado Classic 1500 2WD V8-5.3L (2007)
19. Install the trim panel retaining screws.
Tighten the screws to 2 Nm (18 inch lbs.).
20. Install the windshield pillar garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement.
21. Install the left side I/P junction block.
22. Install the upper intermediate steering shaft to lower shaft retaining bolt. Refer to Upper Intermediate Steering Shaft Replacement.
23. Install the I/P assist handle. Refer to Instrument Panel Assist Handle Replacement.
24. Install the left (3) and right (4) air duct.
25. Install the data link connector.
26. Install the park brake release handle. Refer to Park Brake Release Handle Assembly Replacement.
27. Install the I/P end trim panels.
28. Install the driver side knee bolster and deflector. Refer to Knee Bolster Replacement.
29. Enable the SIR system. Refer to SIR Disabling and Enabling.
30. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
