Silverado Classic 1500 2WD V8-5.3L (2007)
8. Install the clutch actuator cylinder and bolts.
Tighten the bolts to 8 Nm (71 inch lbs.).
9. Install the transmission. Refer to Transmission Replacement.
10. Lower the vehicle.
Transmission Housing Oil Seal Replacement - Rear
Transmission Housing Oil Seal Replacement - Rear (2WD)
Tools Required
^
J 8614-01 Pinion Flange Holder
^
J 6125-1B Slide Hammer
^
J 22834-A Rear Extension Housing Oil Seal Installer
^
J 23129 Universal Seal Remover
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement or Two-Piece Propeller Shaft Replacement.
3. If required, remove the following:
1. The main shaft nut
2. The prop shaft yoke washer
3. The main shaft washer
4. The yoke
