Silverado Classic 1500 4WD V8-4.8L (2007)
6. Remove the shock absorber (4) from the vehicle.
7. Inspect the following parts:
^
The shock absorber for leaks and damage
^
The mounting bolts and the nuts for damage or corrosion
Installation Procedure
1. Install the shock absorber (4).
2. Install the mounting bolt (5) and a new prevailing torque nut (6).
3. Install the shock absorber ball stud (2) to the relay rod (3).
4. Notice:
Refer to Fastener Notice.
Install the J 29193.
5. Tighten the steering linkage installer in order to seat the ball stud in the relay rod.
Tighten the installer to 54 Nm (40 ft. lbs.).
6. Remove the J 29193.
7. Install the prevailing torque nuts.
^
Tighten the shock absorber mounting nut to 40 Nm (30 ft. lbs.).
^
Tighten the ball stud nut to 40 Nm (30 ft. lbs.).
8. Install the engine protection shield, if equipped.
9. Lower the vehicle.