Silverado Classic 2500 2WD V8-6.0L (2007)
7. Notice: Refer to Fastener Notice in Service Precautions.
Tighten the J 41476 mounting bolts until snug. Do not overtighten.
1. Tighten the oil pan-to-rear cover bolts to 12 Nm (106 inch lbs.).
2. Tighten the engine rear cover bolts to 30 Nm (22 ft. lbs.).
8. Remove the J 41476.
9. Install a NEW crankshaft rear oil seal.
10. Install the engine flywheel.