Silverado Classic 2500 2WD V8-8.1L (2007)
4. Install the body control module.
5. Install the floor air outlet duct extension (1) to the floor air duct (2).
Air Temperature Actuator Replacement - Left Side
Air Temperature Actuator Replacement - Left Side
Removal Procedure
Notice: In order to avoid actuator damage, DO NOT apply power to the actuator when it is not installed in the HVAC module.
1. Remove the center console, if equipped.
2. Remove the instrument panel (I/P) insulator panel.
3. Disconnect the electrical connector (1) from the left air temperature actuator (2).
4. Remove the screws from the left air temperature actuator (2).
5. Remove the left air temperature actuator (2) from the HVAC module assembly (3).
Installation Procedure
1. Install the left air temperature actuator (2) to the HVAC module assembly (3).
Notice: Refer to Fastener Notice.
2. Install the screws to the left air temperature actuator (2).
Tighten the screws to 2 N.m (18 lb ft).
3. Install the electrical connector (1) to the left air temperature actuator (2).
4. Install the I/P insulator panel.
5. Install the center console, if equipped.
6. Reprogram the left air temperature actuator. Refer to Actuator Recalibration. See: Testing and Inspection/Programming and Relearning
Air Temperature Actuator Replacement - Right Side
Air Temperature Actuator Replacement - Right Side
