Silverado Classic 2500 2WD V8-8.1L (2007)
2. Install the screws to the left air temperature actuator (2).
Tighten the screws to 2 N.m (18 lb ft).
3. Install the electrical connector (1) to the left air temperature actuator (2).
4. Install the I/P insulator panel.
5. Reprogram the left air temperature actuator. Refer to Actuator Recalibration. See: Testing and Inspection/Programming and Relearning
Air Temperature Actuator Replacement - Right Side
Air Temperature Actuator Replacement - Right Side
Removal Procedure
1. Remove the I/P carrier.
2. Disconnect the electrical connector (4) from the right air temperature actuator (3).
3. Remove the screws from the right air temperature actuator (3).
4. Remove the right air temperature actuator (3) from the HVAC module assembly (2).
Installation Procedure
1. Install the right air temperature actuator (3) from the HVAC module assembly (2).
Notice: Refer to Fastener Notice.
2. Install the screws to the right air temperature actuator (3).
Tighten the screws to 2 N.m (18 lb in).
3. Connect the electrical connector to the right air temperature actuator.
4. Install the I/P carrier.
5. Reprogram the air temperature actuator. Refer to Actuator Recalibration. See: Testing and Inspection/Programming and Relearning
Mode Actuator Replacement (With RPO Code D07)
Mode Actuator Replacement (With RPO Code D07)
Removal Procedure
