Silverado Classic 2500 2WD V8-8.1L (2007)
1. Install the shift lever (1).
2. Connect the shifter electrical connector.
3. Install the wire straps to the harness.
4. Install the harness retaining pin (4) to the instrument panel.
5. Notice:
Refer to Fastener Notice.
Install the knee bolster deflector bracket and nuts (1).
Tighten the nuts to 9 Nm (80 inch lbs.).
6. Install the knee bolster.
7. Install the TORX(r) head shift lever screw.
Tighten the screw to 20 Nm (15 ft. lbs.).
8. Roll the seal over the TORX(r) head shift lever screw.
9. Install the 2 TORX(r) head screws to the lower column trim cover.
10. Install the trim covers.