Silverado Classic 2500 4WD V8-6.6L DSL Turbo (2007)
9. Position the turbocharger coolant return pipe hose clamp.
10. Install the EGR coolant pipe with O-ring seal to the crossover.
11. Install the EGR coolant pipe bolt.
Tighten the bolt to 25 Nm (18 ft. lbs.).
12. Position the EGR hose clamp at the EGR coolant pipe.
13. Install the water outlet.
14. Install the oil fill tube.
15. Position the generator bracket.
16. Install the generator bracket bolts.
Tighten the bolt to 50 Nm (37 ft. lbs.).
17. Install the idler pulley.
Tighten the bolt to 43 Nm (32 ft. lbs.).
18. Install the heater outlet hose bracket bolt to the generator bracket.
Tighten the bolt to 21 Nm (15 ft. lbs.).
