Silverado Classic 2500 4WD V8-6.6L DSL Turbo (2007)
2. Install the engine mount.
3. Perform the following procedure prior to installing the engine mount bracket bolts.
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
3. Apply threadlocker GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the 2 through-bolts.
Tighten the through-bolts to 75 Nm (55 ft. lbs.).
5. Install the bolts holding the engine mount to the engine.
Tighten the engine mount bolts to 58 Nm (43 ft. lbs.).
6. Lower the engine.
7. If 4WD vehicle remove the chain from the front of the engine.
8. If 4WD vehicle, install the generator mounting bracket and the power steering mount bracket bolt.
Tighten the mounting bracket bolts to 50 Nm (37 ft. lbs.).
9. Install the 3 bolts holding the engine mount to the engine mount frame bracket.
Tighten the engine mount to engine mount frame bracket bolts to 65 Nm (48 ft. lbs.).
