Silverado Classic 2500 4WD V8-6.6L DSL Turbo (2007)
FUEL INJECTION FUEL FEED PIPE REPLACEMENT - RIGHT SIDE
REMOVAL PROCEDURE
1. Remove the air cleaner outlet duct.
2. Using a pick or a small flat-bladed screw driver, remove and discard the quick connect fitting clip from the charged air cooler outlet duct.
3. Remove the charged air cooler outlet duct from the intake.
4. Remove the fuel filter.
5. Remove the fuel rail pressure sensor.
6. Prior to removing the fuel injector pipes, use compressed air to blow any debris from between the injector line and fittings. Wipe the fittings clean
of debris.
7. Spray lithium grease, GM P/N 12346293 or equivalent, between the fuel injector line and fittings to assist in containing any debris during removal.
8. NOTE: DO NOT use compressed air to clean debris from the fuel injector inlet after the fuel line is removed. Using compressed air can allow
debris to enter the fuel injector inlet and damage the fuel injector.
Remove the fuel injector pipes.
INSTALLATION PROCEDURE
