Silverado Classic 2500 4WD V8-6.6L DSL Turbo (2007)
Additional Information to Advise Customer
Important
If the vehicle is driven in a snow storm before installing the winter cover and the customer chooses to resolve the issue, they must follow this
procedure using the following steps:
1. Remove ANY ice or snow that may have accumulated in the air intake duct, BEFORE REPLACING the air cleaner element.
2. INSTALL the winter cover BEFORE continuing to drive the truck.
3. Turn OFF the ignition, and all electrical accessories and components.
4. Remove the key from the vehicle, THEN open and close the door.
5. WAIT for 2 minutes to allow the engine control module (ECM) to power down.
This can be verified by watching for the instrument panel cluster (IPC) gage needles to drop slightly.
1. Allowing the ECM to power down will let DTC P0101 revert to a History DTC and the vehicle should return to full power if the issue has been
eliminated.
2. Advise the customer to take the vehicle to the dealer as soon as possible to verify the condition has been eliminated.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table above.
Disclaimer
