Silverado Classic 2500 4WD V8-6.6L DSL Turbo (2007)
Gear Sensor/Switch: Service and Repair
NVG 261-NP2 - Transfer Case
Transfer Case Gear Indicator Switch Replacement
Removal Procedure
1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement.
2. Disconnect the gear indicator switch electrical connector (2).
3. Remove the gear indicator switch.
Installation Procedure
1. Notice:
Refer to Fastener Notice.
Install the gear indicator switch.
Tighten the switch to 27 Nm (20 ft. lbs.).