Silverado Classic 2500 4WD V8-6.6L DSL Turbo (2007)
17. Remove the I/P center support bracket bezel (1).
18. Remove the I/P center support bracket bolt.
19. Remove the I/P carrier retaining bolts. The left side is shown, the right side is similar.
20. Remove the left side door sill plate and cowl trim. Refer to Front Side Door Sill Plate Replacement.
21. Disconnect the clutch pedal engine start switch electrical connector (1).
22. Push the clutch pedal in and squeeze the pushrod bushing tabs in, in order to release the pushrod bushing from the clutch pedal.
23. Remove the pushrod from the pedal.
24. Remove the clutch master cylinder clip from the brake pressure module valve pipe.
