Silverado Classic 2500 4WD V8-6.6L DSL Turbo (2007)
1. Position the cover (4) to the wiper motor.
2. NOTE: Refer to Fastener Notice.
Install the 4 screws (3) to the cover.
Tighten the 4 screws equally to 2.6 N.m (23 lb in).
3. Connect the electrical connector (2) and install the CPA.
4. Install the air inlet panel.
5. Install the wiper arms.
6. Install the radio antenna.
7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Auxiliary Battery) Battery Negative Cable
Disconnection and Connection (Single Battery).
8. Close the hood.
