Silverado Classic 3500 2WD V8-6.0L (2007)
13. Remove the seat belt tower cover.
14. Pull the seat belt and the seat belt bezel through the opening in the seat cover.
15. Lift the remainder of the seat back cover off the foam pad.
16. Carefully remove the foam pad from the frame.
Installation Procedure
1. Attach the foam pad to the frame.
2. Install the seat belt tower.
Notice: Refer to Fastener Notice .
3. Install the bolts which retain the seat belt tower cover.
Tighten the bolts to 1.9 N.m (17 lb in).
4. Install the rear cardboard panel. Engage the panel fasteners.
5. Install the seat back cover partially onto the top of the frame.
6. Feed the seat belt and the seat belt bezel through the tower opening.
7. Install the arm rest clip.
8. Pull the rest of the cover down using a side-to-side motion.
9. Install the armrests, if equipped. Refer to Front Seat Armrest Replacement .
10. Install the head restraint retainers. Refer to Front Seat Head Restraint Retainer Replacement .
11. Fit the seat cover around the air bag cover.
