Silverado Classic 3500 2WD V8-6.0L (2007)
Notice: Refer to Fastener Notice.
2. Install the air temperature actuator retaining screws.
Tighten the screws to 1.6 N.m (14 lb in).
3. Connect the electrical connector (8) to the air temperature actuator (9).
4. Install the IP insulator.
Air Temperature Actuator Replacement - Left Side
Air Temperature Actuator Replacement - Left Side
Removal Procedure
1. Remove the I/P insulator panel.
2. Disconnect the electrical connector (1) from the left air temperature actuator (2).
3. Remove the screws from the left air temperature actuator (2).
4. Remove the left air temperature actuator (2) from the HVAC module assembly (3).
Installation Procedure
1. Install the left air temperature actuator (2) to the HVAC module assembly (3).
Notice: Refer to Fastener Notice.
