Silverado Classic 3500 2WD V8-6.0L (2007)
4. Install the booster inlet hose (1) to the booster.
5. Notice:
Refer to Fastener Notice.
Install the gear inlet hose to the booster.
Tighten both power steering inlet hose fittings to 32 Nm (24 ft. lbs.).
6. Install the booster outlet hose (3) to the booster and install the retaining clamp (2).
7. Remove the drain pan from under the vehicle.
8. Bleed the power steering system.
9. Connect the energy storage box after servicing the vehicle. Refer to Hybrid Battery Service Disconnect/Connect (5.3L Engine w/RPO HP2).
Power Steering Gear Inlet Pipe/Hose Replacement (Rack and Pinion)
Power Steering Gear Inlet Pipe/Hose Replacement (Rack and Pinion)
Removal Procedure
Notice:
Refer to Power Steering Hose Disconnected Notice.
1. Remove the power steering inlet hose (2) from the power steering pump (1).
2. Remove the power steering inlet hose (2) from the power steering gear (3).
Installation Procedure
1. Connect the power steering inlet hose (2) to the power steering gear (3).
