chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Impact Sensor > < Procedures|Page 17795
Page 6
background image

10.  Verify that the tabs on the lower trim cover (1) engage with the tabs on the upper trim cover (2). Snap the tabs together.

Tighten the screws to 1.5 N.m (13 lb in).

11.  On vehicles with a tilt column, align the tilt lever into the steering column.
12.  Slide the tilt lever handle into the steering column until the handle locks into position.

13.  Install the steering wheel onto the steering shaft.
14.  Enable the SIR system. Refer to SIR Disabling and Enabling.  See: Air Bag(s) Arming and Disarming/Service and Repair

Impact Sensor > < Procedures|Page 17795