Silverado Classic 3500 2WD V8-6.0L (2007)
18. Install the range selector cable heat shield.
19. Notice:
Refer to Fastener Notice.
Important:
Install bolts by hand then mechanically tighten the front bolt first and the rear bolt last. Failure to tighten the bolts in the specified order will result
in misalignment of the heat shield.
Install the range selector cable heat shield bolts.
1. Tighten the front bolt to 25 Nm (18 ft. lbs.).
2. Tighten the rear bolt to 25 Nm (18 ft. lbs.).
20. Lower the vehicle.
21. Test the transmission for proper shift operation.
22. If all of the gear positions cannot be achieved, adjust the cable. Refer to Range Selector Lever Cable Adjustment.
