Silverado Classic 3500 4WD V8-6.6L DSL Turbo (2007)
Intake Manifold: Service and Repair
Intake Manifold Replacement - Right Side (LBZ, LLY)
Intake Manifold Replacement - Right Side (LBZ, LLY)
Removal Procedure
1. Remove the center intake manifold.
2. Remove the right fuel rail.
3. Remove the intake manifold bolts/nuts.
4. Important: The intake manifold uses sealer. Pry at the area by the fuel rail bolt holes in order to avoid damage to the sealing surfaces.
Remove the intake manifold.
5. To prevent entry of debris in the cylinder head tape the openings.
6. If required, clean and inspect the intake manifold. Refer to Intake Manifold Cleaning and Inspection.
Installation Procedure
1. Apply a 2 - 3 mm (1/8 inch) wide, by 0.5 - 1.5 mm (1/16 inch) high bead of sealant to the intake manifold. Refer to Sealers, Adhesives, and
Lubricants for the correct part number.