Silverado Classic 3500 4WD V8-6.6L DSL Turbo (2007)
22. Install the charged air cooler inlet duct connector (4) to the turbocharger.
23. Tighten the charged air cooler inlet duct connector to turbocharger clamp (1).
Tighten the clamp to 6 N.m (53 lb in).
24. Fill the cooling system. Refer to Draining and Filling Cooling System (Static Fill) Draining and Filling Cooling System (w/RPO HP2) Draining
and Filling Cooling System (Vac-N-Fill).
25. Connect the negative battery cable.
26. Install the intake manifold cover.
27. If the fuel injectors were replaced, refer to Fuel Injector Flow Rate Programming.
28. Prime the fuel system. Refer to Fuel System Priming.
29. Start the engine. If the engine stalls, repeat the above step.
30. Once the engine starts, inspect for fuel leaks.
