Silverado Classic 3500 4WD V8-6.6L DSL Turbo (2007)
1. Install the locating pins to the NEW encoder motor.
2. Position a NEW actuator insulator gasket to the transfer case.
3. Install the encoder motor.
Notice:
Refer to Fastener Notice.
4. Install encoder motor bolts.
Tighten the bolts, in the sequence shown, to 20 Nm (15 ft. lbs.).
5. Connect the encoder motor electrical connector (7).
6. Connect the transfer case switch electrical connector (2).
7. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement.
8. Install the transfer case shield. Refer to Transfer Case Shield Replacement.
Encoder Motor Sensor Replacement
Encoder Motor Sensor Replacement
Removal Procedure
Important:
For ease of reassembly, shift the transfer case to Neutral prior to removing any components.