Silverado Classic 3500 4WD V8-6.6L DSL Turbo (2007)
Ignition Lock: Service and Repair
Ignition Lock Cylinder Case Replacement
IGNITION LOCK CYLINDER CASE REPLACEMENT
REMOVAL PROCEDURE
1. CAUTION: Refer to SIR Caution.
Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the ignition switch.
3. Remove the turn signal cancel cam.
4. Remove the park lock cable from the lock cylinder housing.
5. Remove 3 TORX(R) screws.
6. Remove the lock cylinder housing from the steering column.
INSTALLATION PROCEDURE
1. NOTE: Refer to Fastener Notice.
Install 3 TORX(R) screws into the lock cylinder housing.
Tighten the TORX(R) screws to 7 N.m (62 lb in).
2. Install the turn signal cancel cam.
3. Install the park lock cable into the lock cylinder housing.
4. Install the ignition switch.
5. Enable the SIR system. Refer to SIR Disabling and Enabling.
6. Refer to Control Module References for programming and setup information See: Testing and Inspection/Programming and Relearning