Silverado Classic 3500 4WD V8-6.6L DSL Turbo (2007)
3. Install the axle shaft seal using the J 21128 (8.6 inch and 9.5 inch LD axles) or the J 29713 (9.5 inch axle).
4. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
5. Install the axle shaft. Refer to Rear Axle Shaft Replacement.
6. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement.
7. Install the tire and wheel assembly.
8. Fill the rear axle. Refer to Rear Axle Lubricant Replacement.
9. Lower the vehicle.
Rear Axle Shaft Seal and/or Bearing Replacement (W/Rear Drum)
Rear Axle Shaft Seal and/or Bearing Replacement (w/Rear Drum)
Tools Required
^
J 8092 Universal Driver Handle-3/4 in - 10
^
J 21128 Axle Pinion Oil Seal Installer
^
J 23690 Axle Shaft Bearing Installer
^
J 2619-01 Slide Hammer
^
J 44685 Rear Axle Seal and Bearing Remover
Removal Procedure
1. Remove the axle shaft. Refer to Rear Axle Shaft Replacement.
2. Remove the axle shaft seal and the bearing from the axle housing using the J 44685 (1) and the J 2619-01 (2).
Installation Procedure