Silverado Classic 3500 4WD V8-6.6L DSL Turbo (2007)
Windshield Washer Pump: Service and Repair
Washer Pump/Reservoir Replacement
WASHER PUMP/RESERVOIR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the battery and battery tray from the vehicle.
2. Remove the inner wheel housing from the vehicle.
3. Disconnect the electrical connector from the washer pump.
4. Disconnect the electrical connector from the washer solvent level sensor.
5. Disconnect the washer hose from the washer pump.
6. Remove the upper bolt from the washer solvent container.
7. Remove the lower bolts from the washer solvent container.
8. Remove the washer solvent container from the vehicle.
INSTALLATION PROCEDURE
1. Install the washer solvent container into the vehicle.
2. NOTE: Refer to Fastener Notice.
Install the lower bolts.
Tighten the bolts to 9 N.m (80 lb in).