Silverado Classic SS V8-6.0L (2007)
1. Install the gasket.
2. Install the booster assembly.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the 4 booster to bulkhead nuts.
Tighten the nuts to 33 Nm (24 ft. lbs.).
4. Install the stop lamp switch.
5. Install the master cylinder to the brake booster.
Tighten the nuts to 33 Nm (24 ft. lbs.).
6. Connect the return hose, the steering gear, and the inlet hoses.
7. Bleed the hydraulic booster system. Refer to Power Steering System Bleeding.
8. Release the park brake and unblock the wheels.