Silverado Classic SS V8-6.0L (2007)
5. Rotate J 41187 toward the clip in order to bend the band onto the clip.
6. Pull on the tool's cutting handle in order to cut off the excess band.
7. Pound the band flat between the latch tabs. Peen the latch tabs over in order to lock the band into position.
8. Twist the halfshaft seal cover (1) until the middle of the cover fits loosely against the halfshaft bar.
9. Position the outboard end of the halfshaft seal cover (1) over the CV joint (2) flat.
10. Important:
Tighten the seal cover clamp (1) as tight as possible without deforming the retaining clip. Clamps that are not tight enough allow the cover to slide
upon the joint. This causes shortened service life.
Use J 41187 in order to tighten the outboard cover clamp (1).
