Silverado SS AWD V8-6.0L VIN N (2003)
Body Emblem: Service and Repair
Emblem/Nameplate Replacement - Door (RPO B4U)
Emblem/Nameplate Replacement - Door (RPO B4U)
Tools Required
J 25070 Heat Gun
Removal Procedure
Important: Use the tape for protection and alignment marks for alignment of the new emblem/nameplate.
1. Apply tape to the area around the door emblem/nameplate.
2. Heat the emblem/nameplate, using a heat gun J 25070 152 mm (6.0 in) from the surface.
3. Apply the heat using a circular motion for about 30 seconds.
Notice: Refer to Exterior Trim Emblem Removal Notice in Service Precautions.
4. Remove the emblem/nameplate from the door surface using a plastic, flat-bladed tool.
5. Remove all adhesive from the door panel surface and the back of the emblem/nameplate using 3M(TM) Scotch Brite molding adhesive remover
disk 3M(TM) P/N 07501 or equivalent.
6. Clean the door surface using varnish makers and painters (VMP) naptha.
Installation Procedure