Silverado SS AWD V8-6.0L VIN N (2003)
5. Remove all adhesive from the end gate panel surface and the back of the emblem/nameplate using 3M(TM) Scotch Brite molding adhesive
remover disk 3M(TM) P/N 07501 or equivalent.
6. Clean the end gate surface using varnish makers and painters (VMP) naptha.
Installation Procedure
1. If the location of the emblem/nameplate has not been marked apply tape.
2. Use the following dimensions in order to mark the proper position of the emblem/nameplate on the end gate.
*
55 mm (2.2 in) (A) From the vertical edge
*
43 mm (1.7 in) (B) From the horizontal edge
3. Warm the end gate surface with a heat gun J 25070 152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).
4. Apply tape over the outer surface of the emblem/nameplate to ensure alignment.
Important: Do not touch the adhesive backing of the emblem/nameplate.
