Silverado SS AWD V8-6.0L VIN N (2003)
5. Remove the rear tail lamp assembly from the vehicle.
6. Remove the bolts that retain the fender to the rear pillar.
7. Remove the lower bolts from the rear of the fender.
8. Disconnect the electrical connectors from the running lights, if equipped.
9. Remove the screws from the outer wheel well.
10. Remove the bolts from the bottom of the fender.
11. With an assistant, pivot the fender from the bottom upward to approximately 90 degrees in order to remove the fender from the retainers.
INSTALLATION PROCEDURE
