Silverado SS AWD V8-6.0L VIN N (2003)
9. Unclip the seat trim cover from the seat cushion frame.
10. Using a side motion, carefully separate the seat cushion trim cover from the seat cushion pad.
11. If replacing the front passenger seat cushion you must also replace the Inflatable Restraint Passenger Presence System. Refer to Inflatable Restraint
Passenger Presence System Replacement - Front in Restraint Systems.
CAUTION: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. The bladder, the
pressure sensor, the seat cushion, and the control module are assembled and calibrated as a unit. Using only some of the components in the
service kit will cause the passenger presence system to operate improperly.
12. Remove the pad from the seat cushion frame.
13. Remove the seat cushion heater element, if equipped.
INSTALLATION PROCEDURE
1. Install the seat cushion heater element, if equipped.
2. Install the Inflatable Restraint Passenger Presence System.
3. Install the seat cushion pad to the seat cushion frame.
