Silverado SS AWD V8-6.0L VIN N (2003)
8. Install the quarter shaft shield.
9. Install the quarter shaft shield nut and the bolt.
-
Tighten the quarter shaft shield nut and the bolt to 25 N.m (18 lb ft).
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
11. Lower the vehicle.
12. With the engine OFF gradually apply the brake pedal to approximately 2/3 of it's travel distance.
13. Slowly release the brake pedal.
14. Wait 15 seconds then repeat steps 12-13 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
