Silverado SS AWD V8-6.0L VIN N (2003)
Brake Rotor/Disc: Service and Repair
Brake Rotor Replacement - Rear (W/Nys)
Brake Rotor Replacement - Rear (W/NYS)
Tools Required
- J 41013 ........................................................................................................................................................................................... Rotor Resurfacing Kit
- J 42450-A .............................................................................................................................................................................. Wheel Hub Resurfacing Kit
Caution: Refer to Brake Dust Caution in Cautions and Notices.
Removal Procedure
1. Release the park brake.
2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
4. Mark the relationship of the rotor to the hub.
5. Install a C-clamp over the body of the brake caliper, with the C-clamp ends against the rear of the caliper body and the outboard disc brake pad.
6. Slowly tighten the C-clamp until the pistons are pushed into the caliper bores enough to remove the caliper from the pads.
7. Remove the C-clamp from the caliper.
8. Remove the nut and the bolt from the quarter shaft shield.
9. Remove the shield.
