Silverado SS AWD V8-6.0L VIN N (2003)
1. Install the brake caliper bracket (1).
2. Perform the following procedure before installing the brake caliper bracket mounting bolts.
2.1.
Remove all traces of the original adhesive patch.
2.2.
Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
2.3.
Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
Note: Refer to Fastener Notice in Cautions and Notices.
3. Install the caliper bracket mounting bolts (2).
-
Tighten the brake caliper bracket mounting bolts to 175 N.m (121 lb ft) (15 Series).
-
Tighten the brake caliper bracket mounting bolts to 300 N.m (221 lb ft) (25 and 35 Series).
4. Install the anti-rattle clips to the brake caliper bracket.
5. Install the brake pads to the brake caliper bracket.
6. Slide the brake pads in until they contact the rotor.
7. Install the brake caliper. Refer to Brake Caliper Replacement - Front.
8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
9. Lower the vehicle.
10. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
11. Slowly release the brake pedal.
12. Wait 15 seconds, and then repeat steps 10-11 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
Brake Caliper Overhaul - Front
Brake Caliper Overhaul - Front
Caution: Refer to Brake Dust Caution in Cautions and Notices.
Caution: Refer to Brake Fluid Irritant Caution in Cautions and Notices.
Disassembly Procedure
Caution: Do not place your fingers in front of the piston in order to catch or protect the piston while applying compressed air. This could result
in serious injury.
Important: The brake calipers contain phenolic pistons that have stainless steel caps that contact the brake pad. Use compressed air to remove the piston
from the caliper.
1. Remove the brake caliper from the vehicle. Refer to Brake Caliper Replacement - Front.
2. Place a thin piece of wood in front of the piston in order to prevent damage. Remove the piston by directing compressed air into the brake hose
inlet fitting port of the brake caliper housing.
