Silverado SS AWD V8-6.0L VIN N (2003)
1. If re-using the old coolant heater, apply thread sealant GM P/N 12346004 (Canadian PIN 10953480), or equivalent to the threads.
Notice:
Refer to Fastener Notice in Service and Precautions.
2. Install the coolant heater to the engine block.
Tighten the coolant heater to 50 Nm (37 ft. lbs.).
Notice:
The heater cord must not touch the engine, hot pipes, manifold, or any moving parts. Route the cord to the left front of the engine compartment
securing with tie straps as necessary to prevent damage.
3. Connect the coolant heater electrical connector (2).
4. Lower the vehicle.
5. Fill the cooling system.
