Silverado SS AWD V8-6.0L VIN N (2003)
1. Loosen the intake manifold sight shield bolt.
2. Remove the sight shield from the sight shield retainer.
3. Loosen the left fuel rail cover bolts.
4. Remove the left fuel rail cover.
5. Remove the surge tank/heater hoses from the clip on the right fuel rail.
6. Loosen the right fuel rail cover bolts.
7. Remove the right fuel rail cover.
8. Remove the sight shield retainer bolts and retainer, if required.
Installation Procedure
Notice:
Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Fastener Notice
1. Install the sight shield retainer and bolts, if required.
Tighten the bolts to 5 Nm (44 inch lbs.).
