Silverado SS AWD V8-6.0L VIN N (2003)
6. Remove and discard the centering tab (1).
7. Install the retaining ring (1). Verify that the ring (1) is firmly seated in the groove on the upper shaft (2).
NOTE: Gently pull on the lower coil assembly wire in order to remove any wire kinks inside of the column assembly. Verify that there are NO kinks
or bends in the SIR coil assembly wire. If a kink or bend is present, interference may occur with the shaft lock mechanism. Turning the steering wheel
may cut or damage the wire.
8. Install the wire harness assembly (4) into the wire strap (5).
9. Install the wire harness strap (2) into the upper tilt head assembly (1).
10. Install wire harness straps (3) to the wire harness assembly.
11. Install the steering column trim covers.
12. Enable the SIR system. Refer to SIR Disabling and Enabling Zone3.
