Silverado SS AWD V8-6.0L VIN N (2003)
Power Steering Line/Hose: Service and Repair
Power Brake Booster Inlet Hose Replacement
POWER BRAKE BOOSTER INLET HOSE REPLACEMENT
REMOVAL PROCEDURE
1. Install a drain pan under the vehicle.
NOTE: Refer to Power Steering Hose Disconnected Notice in Service Precautions.
2. Remove the brake booster inlet hose (1) from the brake booster (2).
3. Remove the brake booster inlet hose from the power steering pump.
4. Remove the brake booster inlet hose from the vehicle.
INSTALLATION PROCEDURE
1. Route the hose in the same position the hose occupied prior to removal.
NOTE: Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.
2. Install the brake booster inlet hose (1) to the brake booster (2).
3. Install the brake booster inlet hose to the power steering pump.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the brake booster inlet hose fittings to 28 N.m (20 lb ft).
4. Remove the drain pan from under the vehicle.
