Replace Rear Wheel Steering Position Sensor in Silverado SS AWD V8-60L (2003) | Page 14944
Tighten the bolts to 4 N.m (35 lb in).
4. Install the rear wheel position sensor cover (4).
5. Connect the electrical connector (1).
6. Install the steering gear protection shield (1) and retaining bolts (3).
Tighten
Tighten the steering gear protection shield retaining bolts to 180 N.m (132 lb ft).
7. Lower the vehicle.
8. Perform a four wheel alignment. Refer to Measuring Wheel Alignment (With Rear Wheel Steering) Measuring Wheel Alignment (Without Rear
Wheel Steering) in Wheel Alignment.