Silverado SS AWD V8-6.0L VIN N (2003)
4. Remove the fill plug.
5. Remove the drain plug.
6. Drain the fluid from the front differential carrier assembly.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the drain plug.
Tighten the drain plug to 33 Nm (24 lb ft).
2. Fill the differential carrier assembly with axle lubricant. Use the proper fluid.
3. Install the fill plug.
Tighten the fill plug to 33 Nm (24 lb ft).
4. Install the front differential carrier shield, if equipped.
5. Lower the vehicle.
