Silverado SS AWD V8-6.0L VIN N (2003)
10. Mount the base of J 36652 in a vise.
11. Check the inboard stroke position.
^
Use measurement A for the K1500 models.
^
Use measurement B for the K2500, K3500, and Hummer 2 models.
12. Position the inboard end (tripot end) of the halfshaft assembly into the base of J 36652.
13. Install the top half of J 36652.
14. Align the swage ring (2) and the swage ring clamp.
15. Insert the bolts.
Hand tighten the bolts in J 36652 until the bolts are snug.
Important: Align the following during this procedure:
^
The tripot seal (3)
^
The housing (1)
^
The swage ring (2)